Tristar WG-2424 Instruction Manual download pdf (Page 5)

BEFORE THE FIRST USE

• Take the appliance andaccessoriesoutthebox.Removethe

stickers,protective foilorplasticfrom thedevice.

• The device can only function correctly if you stand on the contact

surface with bare, dry feet!

• The main principle of this device is based on the measurement of the

electric impedance within the human body. In order to determine the

actual body data, the device leads a weak, unnoticeable electric signal

through your body.

• This signal is generally safe! However, please read our special safety

instructions!

• The method of measurement is referred to as "bioelectric impedance

analysis" (BIA), a factor which is based on the relationship between

body weight and associated body water percentages as well as on other

biological data(age, gender, body weight).

• There are heavy persons with a well-balanced percentage between fat

and muscle mass, and there are seemingly slim persons with signicantly

high body fat values, fat is a factor that puts serious strain on the body, in

particular the cardio-vascular system. Therefore, controlling both values

(fat and weight) is a prerequisite for health and tness.

USE

• The scales are factory set with the units"kg" and "cm". To change the

settings to "lb" or "kg" and 'Ft:in",proceed as follows: On the back side of

the scale beside the battery compartment a switch can be found, push

the below switch, choose between the measuring units kg/lb/st.

WEIGHING FUNCTION

• Place the scale on a hard, at surface (avoid carpets). An uneven oor

contributes to inaccurate measurements.

• Stand on the scales with both feet. The device switches on automatically.

• Distribute your weight equally and wait for the scale to determine your weight.

• The digits on the display will ash before your exact weight will be shown.

• In order to extend the battery life, the device will automatically turn o

10 seconds after you have stepped o the scale.

SAVING PERSONAL DATE

• The scale has default values that you can change, as described below.

• Carry out the following steps in sequence and within a few seconds,

otherwise the device will automatically cancel the input mode.

• Press the button SET. The memory space will ash on the display (P0).

Conrm the setting by pressing SET or select another memory space by

pressing the UP/DOWN button and then SET to go to the next setting.

• The symbol for"male" or "female" will ash. Conrm the setting by

pressing SET or use the UP/DOWN button to choose the symbol for your

gender and then press to go the next setting.

• The height setting will ash. Select your height by pressing the UP or

DOWN button. Holding down one of the buttons will accelerate the

process. Conrm your entry by pressing SET.

• The setting AGE will ash. Select your age by pressing the UP or DOWN

button. Holding down one of the buttons will accelerate the process.

Conrm your entry by pressing SET.

• The device can only function correctly if you stand on the device with

bare,dry feet. If necessary wipe the contact surface to improve the

results.

• Due to the signicant uctuation of body fat the optimal testing time is

between 6 p.m. And 8 p.m, since the body fat remains very consistent

during this period of time.

EN INSTRUCTION MANUAL

1 2 3 4 5 6 7 8 9 10 ... 47 48

Comments to this Manuals

No comments

Tristar WG-2424 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Personal scales Tristar WG-2424